📢
Hub Chatter
Log In
Loading…
Cnc Plasma Cutting - Hub Chatter
c/cnc-plasma-cutting
10
c/cnc-plasma-cutting
•
park.troy
•
1d ago
Bought a $200 plasma torch height controller off a Marketplace listing in Aurora that was DOA
0 comments
Share
22
c/cnc-plasma-cutting
•
hugow30
•
1d ago
Tried running my Hypertherm at 45 amps on 3/16 plate and the dross came out glassy smooth
1 comments
Share
17
c/cnc-plasma-cutting
•
evaadams
•
3d ago
Warning: the old guy at the welding supply in Dayton told me my cut height was killing tips, and he was dead on
0 comments
Share
17
c/cnc-plasma-cutting
•
gibson.oliver
•
5d ago
Changed my mind on cut height after burning up 4 tips on 3/16 plate
0 comments
Share
16
c/cnc-plasma-cutting
•
troy_sanchez8
•
5d ago
Showerthought: found out my ground clamp was on painted steel for like 8 months
0 comments
Share
18
c/cnc-plasma-cutting
•
nathan_barnes
•
5d ago
Pro tip: slowing my pierce delay to 0.8 seconds quit blowing out tips on 3/16 plate
0 comments
Share
20
c/cnc-plasma-cutting
•
holly_williams
•
5d ago
DAE cut a whole sheet of 11 gauge into brackets before realizing the tip was shot?
0 comments
Share
25
c/cnc-plasma-cutting
•
ward.piper
•
6d ago
Why does nobody mention checking your ground clamp until it ruins a cut
0 comments
Share
19
c/cnc-plasma-cutting
•
claire378
•
7d ago
My first clean 1/4 inch cut on 3/16 plate happened last Thursday in my garage
0 comments
Share
23
c/cnc-plasma-cutting
•
kevin_hernandez83
•
8d ago
Appreciation post: a scrap bin argument in Dallas changed my mind on slower cut speeds
0 comments
Share
13
c/cnc-plasma-cutting
•
the_wyatt
•
8d ago
Burned through a whole nozzle in 20 minutes because I bumped the arc voltage on .080 aluminum
0 comments
Share
13
c/cnc-plasma-cutting
•
jake_martin16
•
9d ago
Just realized my dross problem disappeared after I swapped one thing on the table
0 comments
Share
6
c/cnc-plasma-cutting
•
the_parker
•
11d ago
Showerthought: a burnout on 3/8 plate at the Tulsa fair made me rethink my whole pierce delay
1 comments
Share
11
c/cnc-plasma-cutting
•
jade_hernandez
•
12d ago
Vent: my torch's ground clamp came loose mid sheet and I wasted a whole 4x8
0 comments
Share
21
c/cnc-plasma-cutting
•
grace419
•
15d ago
Guy running the counter at Airgas said my tip was too big for 14 gauge and it clicked
0 comments
Share